Air 45 ft (14 m) Guyed Tower Kit
The AIR tower kit includes a simple yet effective elbow/tee for its
base. Combined with a short length of tubing this type of base
eliminates the need for a concrete pad, base plate and a swivel for the
base of the tower.
A simple extruded aluminum, coupling clamp allows the use of a wide
selection of different kinds of tubing, depending on availability, site
requirements and customer preference. Threaded coupling points are
eliminated, allowing lighter materials to be used with the same or
greater strength than a threaded pipe tower. The upper guy wire
attachment clamps onto the upper mast section. This reduces the number
of pieces of tubing used to construct the tower and reduces the
stresses concentrated at this point. While this method is easier to
assemble, the main benefit is an increase in the fatigue strength of
the tower, which allows lighter weight materials to be used with
greater safety. Pre-cut and swaged guy wires eliminate wire measuring
and cutting.
Manual I Spec Sheet
A Revolution in Tower Design
| Kits
include:
Base Connector
Upper Wire Set (280 ft. pre-cut)
Lower Wire Set (160 ft. pre-cut)
Base Staples
3/8" x 1 ½" Bolt
3/8" Locknut
Cable Thimbles
Cable Clamps
Set Up
Kit
|
45 ft (14
m)
1
1
1
2
3
3
8
16
1*
|
* Note: This 45 foot Tower Kit includes a setup kit to raise the
tower. If more than one tower is to be erected, a single
setup up kit can be used for any towers to be installed. See
below for kit details.
| Kits include:
Gin Pole Cap
100 Foot Rope
Snap Links
8 Foot Cable
3/8" x 1-1/2" Bolt
3/8" Locknut
|
Quantity)
1
1
3
1
1
1
|
Pipe Pieces Needed:
(available at fence suppliers)
-
24 foot (7.2 meter) length for tower
-
21 foot (6.3 meter) length for tower
-
6 foot (1.8 meter) length for tower base
- 21 foot (6.3 meter) length
for gin pole
|
|
Pipe Requirements
|
|
Tower Kits use 1-7/8 inch (47.5 mm)
Steel Tubing
|
|
Maximum Wind Speed
|
Maximum
Wind Speed
70 mph
80 mph
90 mph
|
Recommended
Wall Thickness
.065 inch (1.65 mm)
.090 inch (2.3 mm)
.140 inch (3.6 mm)
|
Pipe
Schedule
n/a
Schedule 20
Schedule 40
|
