MC3 Solarline 1 Array Output Cables Cat. No. MC3-52.91xx Weight 1 lbs

Multi-Contact Solarline family of connectors delivers a flexible system solution for time-saving, dependable series-cabling of solar modules.   All module manufactures supply their grid-tie modules with pre-assembled outputcables, tested and ready  for connection.  This saves considerable time during an installation and greatly increases reliability over wire junction boxes.  These cable couplers are fully touch-protected and designed for up to 100 wats and 30 amps.  They are also waterproof.  For parallel connection of modules in 12-to 48-volt systems, Multi-Contact makes branch connectors for use with currents up to 30 amps.  In 2007, PV manufactures began switching to Multi-Contact Solarline 2 locking connectors to meet future electrical code requirements. Multi-Contact plug-andplay connector system allows for the PV arrays to be pre-assembled and pre-wired in the shop or on site.  Proper crimping to the wire and insulator assembly requires special tools. MC3 Solarline 1 Array Output Cables:   These cables have the old style Multi-Contact soft rubber conectors on each end.  Use the output cables between PV arrays with Multi-Contact cable outputs and junction boxes or grid-tie inverters.  They have a male connector on one end and a female connector on the other end.  Use them to extend module output cables or cut anywhere along the wire obtain the needed length of male and female cable to run from the ends  of a module string to a combine box or to an inverter.  (Example, if you need a 30' male and a 20' female, order a 50' cable.)  Made with black #10 AWG USE-2 sunlight-resistant cable. Lengths: MC3-52.9107, Cable length 6 foot : $21.00 MC3-52.9111, Cable length 15 foot : $26.00 MC3-52.9115, Cable length 30 foot : $34.00 MC3-52.9116, Cable length 50 foot : $45.00 MC3-52.9118, Cable length 100 foot : $72.00